Wave soldering is the most widely used method in electronics industry for soldering through-hole electronic components. Components glued to the bottom of a mixed-technology PCB require wave soldering, although the required wave geometry is different from that for through-hole electronic components. In the most common wave soldering geometry, the dual-wave type, one wave is turbulent and the other wave is smooth, as in conventional technology soldering.
The need for wave soldering equipment can also be met by simply retrofitting the conventional solder pot with the dual pot – at a small fraction of the cost of a new machine. A completely new machine is not necessary.
Another wave geometry for printed circuit board Assembly that is popular for surface mounting in SMT is a vibrating single wave known as the omega wave. Like the dual wave geometry, it helps in reducing solder defects. The agitation provided by the dual or vibrating wave dislodges trapped flux gas that forms during wave contact and forces solder into areas with poor wetting angles. Proper component orientation is also very important.
Some electronic companies have successfully used drag soldering equipment and techniques. Ideally, the wave or drag soldering process should be limited to soldering ceramic surface mount resistors and capacitors. Small outline transistor (SOT) components are difficult to wave or drag solder (Check: Hand soldering of SMD).
Wave and foam fluxers are generally used to apply flux to the board. Spray Fluxers are being used to apply very controlled amounts of flux, especially when no-clean fluxes are used. The development of an appropriate solder profile is important for best results.
The original link: http://www.nod-pcba.com/news/252-en.html
没有评论:
发表评论